Last Updated on June 18, 2024 by teamobn
Attach the remaining slats of your Adirondack chair in the same manner, spacing as evenly as possible.
You’ll want to dry fit all the slats first so you have an idea of how to space them.
This is a time-consuming part. You’ll want to be careful drilling the pilot holes into the seat stringer. Be patient! You don’t want to blow it now.
If you’ve got the means, I recommend routing the edges of the armrests. If not, you can skip to the next step.
Measure and mark 20″ from the bottom of the rear back support.
Move the Adirondack chair’s armrest into position. The 20″ mark should line up with the bottom edge of the armrest. Use a screw to tack the armrest in place, prop it up, or clamp it, whatever. Just keep it in place.
Drill three pilot holes through the armrest and into the front leg and armrest bracket of your Adirondack chair. Countersink the pilot holes and fasten them with screws.
To attach the rear part of the Adirondack chair’s armrest, drill two pilot holes and a countersink. Attach with two 1.25″ screws. I’ve seen similar designs that incorporate a carriage bolt, washer, and nut here, instead of two screws. A stronger way to go!
Grab your wood putty and get to work. Fill all the holes you can.
I like to wipe off the residual putty with a wet cloth while it’s fresh. Sanding it off can be a real pain and also ruin the way your stain or paint looks.
Then get to work sanding it down. At the minimum, you’ll need to lightly sand off the shiny glaze to allow stain penetration or paint adhesion.
An inexpensive project, and a beautiful piece of furniture – wouldn’t that make you feel good already? Now, how about finally grabbing your favourite drink and relaxing on your Adirondack chair? 🙂
Thanks to jkratman for this great project.
